Vision Fitness ST780 - Manual (Page 10)

3
STEP
• Line up the holes in the bottom of the
backrest (J02) with the holes in the support
tube (AT2). Insert a bolt (M10x60) and a
flat washer (10.2x22x2) up through the
bottom of the tube and tighten.
• Line up the holes in the bottom of the
seat (J01) with the holes in the support
tube (AT1). Insert a bolt (M10x60) and a
flat washer (10.2x22x2) up through the
bottom of the tube and tighten.
• Slide the roller pad rod (H06) thru either
the lower hole (used for performing
exercises such as abdominal crunches
and decline chest movements) or the
upper hole (used for holding the body
down when performing exercises such as the
lat pulldown) of the accessory tube (AH2).
Make sure the rod is centered, before sliding
a roller pad (H13) on each end.
PINK BAG
AH2
H06
H13
H13
AT1
J01
J02
AT2
10