Vanguard Heating VSGF-28PTE - Manual (Page 16)

www.desatech.com 113135-01C 16
INSTALLATION
Continued
INSTALLING LOGS
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
Each log is marked with a number. These numbers
will help you identify the log when installing. It
is very important to install these logs exactly as
instructed. Do not modify logs. Only use logs
supplied with heater.
1. Place front log (#1) on top of the grate. Make
sure the notches in the bottom of the log fit
over the grate prongs (see Figure 24). Push
back of logs flush with metal grate bars.
2. Rest middle log (#2) behind metal posts on grate
assembly. Make sure the grooves in the bottom
of the log fit over the grate. Bring the log forward
next to the metal posts (see Figure 25).
3. Slide the grooves in the back of the rear log
(#3) against the rear grate prongs. Make sure
the log fits securely over the prongs (see Fig-
ure 26). Make sure log is completely vertical
and not leaning in toward burner where the
flame will touch the log.
4. Install fireplace screen by slipping notches
of fireplace screen over screws on front of
fireplace (see Figure 27).
Front Log (#1)
Grate
Prongs
Metal Grate Bars
Figure 24 - Installing Front Log (#1)
Notch
Middle Log (#2)
Metal Post
Grate
Figure 25 - Installing Middle Log (#2)
Rear Log (#3)
Grate
Prong
Grate
Prong
Groove
in Back
of Log
Groove
in Back
of Log
Figure 26 - Installing Rear Log (#3)
Groove
Groove
Figure 27 - Installing Fireplace Screen
Notches
Screws for
Mounting
Screen