Important instructions (continued), Save these instructions – Vornado TouchStone 600 User Manual
Page 3
3
Owner’
s Guide
|
EN
GLI
SH
IMPORTANT INSTRUCTIONS (continued)
DO check periodically for a secure plug/outlet fit. If the plug does not fit snugly
into the outlet or if the plug becomes very hot, the outlet may need to be replaced.
Check with a qualified electrician to replace the outlet.
DO unplug the heater when not in use by pulling the plug straight out from the
outlet. Inspect the heater’s cord periodically. DO NOT use a heater with a damaged
cord. Return heater to Vornado for examination, electric or mechanical adjustment
or repair.
This heater is equipped with a thermal safety shut-off system, designed to turn off the
heater when an internal overheating condition is detected (see Resetting the Unit
section under Safety Features for instruction on how to reset Heater).
This heater operates with a RF (Radio Frequency) remote control. Interference
between this remote and other remote-control-operated electrical appliance in your
home is possible.
This heater is for use on 120 volts. The cord has a plug as shown at A in the
illustration below. If a grounding receptacle is not available, an adapter as shown
at B is available for connecting three-blade grounding-type plugs to two-slot
receptacles. The green grounding plug extending from the adapter must be
connected to a permanent ground such as a properly grounded outlet box shown at B.
The adapter should not be used if a three-slot grounded receptacle is available.
HEATERS SHOULD BE KEPT AWAY FROM CHILDREN AND NOT BE PLACED IN A
CHILD’S ROOM WITHOUT SUPERVISION.
FOR RESIDENTIAL USE, INDOOR ONLY. NOT FOR USE IN ANIMAL PENS OR
OUTDOOR BUILDINGS.
SAVE THESE INSTRUCTIONS