Vision Fitness R2200HRT - Manual (Page 5)

5
1
STEP
1
STEP
• Slide the rear foot in place and
attach two screws (M8 x 20L), two
screws (M8 x 65L), and four lock
washers (M8), using the blue-handled
5
MM Allen wrench.
• Slide the rubber sleeve to the proper
position at the bottom of the joint.
ORANGE BAG
2
STEP
2
STEP
• Place the seat bracket on the seat
frame. With the 6
MM Allen wrench
secure the seat bracket with the four
screws (M8 x 20L).
• Loosen and take off the screw on
the seat lever with the 4
MM Allen
wrench. Turn the seat lever so the
screw holes line-up and reinstall the
screw with the 4
MM L-shaped Allen
wrench to secure the seat lever.
• Place the seat handlebar into the
proper position on the seat frame.
With the 5
MM Allen wrench secure the
seat handle bar with four screws
(M8 x 15L) and four lock washers
(M8).
• This product features a lumbar
control seat. To secure this seat to the
frame, remove the plastic cover from
the back of the upright seat cushion.
Use the four screws (M6 x 55L) and
four lock washers (M6) to attach
the cushions to the frame. Tighten with
the 4
MM L-shaped Allen wrench. Snap
the plastic cover onto the back of the
upright seat cushion.
BLUE BAG