Viper SCRUBBER FANG 18C - Manual (Page 3)

ENGLISH USER MANUAL
INTRODUCTION
NOTE
The numbers in brackets refer to the components shown in Machine Description
chapter.
MANUAL PURPOSE AND CONTENTS
The purpose of this Manual is to provide the operator with all necessary information to use the
machine properly, in a safe and autonomous way. It contains information about technical data, safety,
operation, storage, maintenance, spare parts and disposal. Before performing any procedure on the
machine, the operators and qualified technicians must read this Manual carefully. Contact Viper in
case of doubts concerning the interpretation of the instructions and for any further information.
TARGET
This Manual is intended for operators and technicians qualified to perform the machine maintenance.
The operators must not perform procedures reserved for qualified technicians. Viper will not be
answerable for damages coming from the non-observance of this prohibition.
HOW TO KEEP THIS MANUAL
The User Manual must be kept near the machine, inside an adequate case, away from liquids and
other substances that can cause damage to it.
DECLARATION OF CONFORMITY
The declaration of conformity, supplied with the machine, certifies the machine conformity with the
law in force.
NOTE
Two copies of the original declaration of conformity are provided together with the
machine documentation.
CE-declaration is print in Quick Start Guide
IDENTIFICATION DATA
The machine model and serial number are marked on the plate(16)
The machine model year is written in the declaration of conformity and it is also indicated by the first
two figures of the machine serial number.
This information is useful when requiring machine spare parts. Use the following table to write down
the machine identification data.
MACHINE model......................................................
MACHINE serial number..........................................
OTHER REFERENCE MANUALS
– Service Manual (that can be consulted at Viper Service Centers)
– Spare Parts List (see www.viperclearing.eu)
SPARE PARTS AND MAINTENANCE
All necessary operating, maintenance and repair procedures must be performed out by qualified
personnel or by Viper Service Centers. Only original spare parts and accessories must be used.
Contact Viper for service or to order spare parts and accessories, specifying the machine model and
serial number.
2 FANG 18C 80188EU(1)2009-01