Viper SCRUBBER FANG 18C - Manual (Page 6)

USER MANUAL ENGLISH
– While using this machine, take care not to cause damage to people or objects.
– Do not bump into shelves or scaffoldings, especially where there is a risk of falling objects.
– Do not put any can containing fluids on the machine.
– The machine working temperature must be between 0°C and +40°C.
– The machine storage temperature must be between 0°C and +40°C.
– The humidity must be between 30% and 95%.
– Do not use the machine as a means of transport.
– Do not use the machine on slopes with a gradient exceeding the specifications.
– Do not allow the brush/pad to operate while the machine is stationary to avoid damaging the floor.
– In case of fire, use a powder fire extinguisher, not a water one.
– Do not tamper with the machine safety guards and follow the ordinary maintenance instructions
scrupulously.
– Do not allow any object to enter into the openings. Do not use the machine if the openings are
clogged. Always keep the openings free from dust, hairs and any other foreign material which could
reduce the air flow.
– Do not remove or modify the plates affixed to the machine.
– If the machine is used according to the instructions, the vibrations are not dangerous. The machine
vibration level is less than 2.5 m/s2 (98/37/EEC-EN 1033/1995).
– The Hand/arm vibration levels are well below 2,5 m/s2 (measured according to ISO 5349), which is the
limit for an 8 hour continuous working period.
– Full body vibrations (ride on machines, measured on the seat) have to be not more than 0,5 m/s2
(measured according to ISO 2631-1), also the limit for 8 hour continuous operation.–
– This machine cannot be used on roads or public streets.
– Pay attention during machine transportation when temperature is below freezing point. The water in
the recovery tank or in the hoses could freeze and seriously damage the machine.
– Use brushes and pads supplied with the machine and those specified in the User Manual. Using
other brushes or pads could reduce safety.
– In case of machine malfunctions, ensure that these are not due to lack of maintenance. If necessary,
request assistance from the authorised personnel or from an authorised Service Center.
– If the machine
• does not work properly
• is damaged
• has water or foam leaks
• has been left outdoors exposed to bad weather conditions
• is wet or has been dropped into water
turn it off immediately and contact Viper Service Center or a qualified technician.
– If parts must be replaced, require ORIGINAL spare parts from an Authorised Dealer or Retailer.
– To ensure machine proper and safe operation, the scheduled maintenance shown in the relevant
chapter of this Manual, must be performed by the authorised personnel or by an authorised Service
Center.
– Carefully read all the instructions before performing any maintenance/repair procedure.
– Do not wash the machine with direct or pressurised water jets, or with corrosive substances.
– The machine must be disposed of properly, because of the presence of toxic-harmful materials
(electrical components, etc.), which are subject to standards that require disposal in special centres
(see Scrapping chapter).
80188EU(1)2009-01 FANG 18C 5