Viper SCRUBBER FANG 18C - Manual (Page 5)

ENGLISH USER MANUAL
GENERAL INSTRUCTIONS
Specific warnings and cautions to inform about potential damages to people and machine are shown below.
DANGER!
– Always disconnect the power supply cable when the machine is not in use, before performing
maintenance procedures, before replacing
the parts before opening any access panel.
– This machine must be used by properly trained and authorised personnel only. Children or disabled
people cannot use this machine.
– Do not wear jewels when working near electrical components.
– Do not work under the lifted machine without supporting it with safety stands.
– Do not operate the machine near toxic, dangerous, flammable and/or explosive powders, liquids or
vapours.
WARNING!
– The machine power supply cable is grounded and the relevant plug is grounded too. In case of
machine malfunction or breakdown, grounding connection reduces the risk of electric shock.
– The power supply cable plug must be connected to an appropriate outlet, which is grounded
according to law in force.
– This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety.
– Children should be supervised to ensure that they do not play with the appliance.
– if the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
– Improper connection can cause electric shock. Consult a qualified technician to make sure that the
outlet is properly grounded.
– Do not tamper with the power supply cable plug. If the power supply cable plug cannot be
connected to the outlet, have new grounded outlet installed by a qualified technician, according to
the law in force.
– Before connecting the power supply cable to the electrical mains, check that frequency and voltage,
shown on the machine serial number plate, match the electrical mains voltage.
– Regularly check the power supply cable for damages, cracks, cuts, etc. If the power supply cable is
damaged, replace it immediately.
– To avoid any risk, if the power supply cable is damaged, contact Viper Service Center or a qualified
technician.
– Do not pull or carry the machine by the power supply cable and never use the power supply cable as a
handle. Do not close a door on the power supply cable, or pull the power supply cable around sharp
edges or corners. Do not run the machine on the power supply cable.
– Keep the power supply cable away from heated surfaces.
– To reduce the risk of fire, electric shock, or injury, do not leave the machine unattended when it is
plugged in. Disconnect the machine from the electrical mains when not in use and before performing
maintenance procedures.
– To avoid electric shock, do not expose the machine to rain or other bad weather conditions.
Store the machine indoors, in a dry place.
– Do not allow to be used as a toy. Close attention is necessary when used near children.
– Use only as shown in this Manual. Use only Viper's recommended accessories.
– Take all necessary precautions to prevent hair, jewels and loose clothes from being caught by the
machine moving parts.
– Do not leave the machine unattended without being sure that it cannot move independently.
– Do not use the machine on slopes with a gradient exceeding the specifications.
– Do not use the machine in particularly dusty areas.
4 FANG 18C 80188EU(1)2009-01