Verizon GT704WGB User Manual
Page 60
Wireless DSL Gateway User Manual
10/16/08
59
© 2008 Verizon. All Rights Reserved.
5.7b Telnet
To access the Gateway via Telnet, activate Telnet by selecting the appropriate
“On” radio button and writing down the WAN IP address of the Gateway (see
“WAN IP Address”). On a computer outside the network running a Telnet
program, enter the Gateway’s WAN IP address to access the Gateway.
Note: Before remote management or Telnet can be activated, the administrator
password must be set. To do this, go to the Home screen, click Security, then
select Admin User Name and Password. Follow the instructions in the
subsequent screens.
When finished in this screen, click Apply to activate any changes made.
5.7c Telnet Timeout Setting
Selecting Telnet Timeout Setting in the “Advanced Setup” screen generates
the “Telnet Timeout Setting” screen. Select a period of time from the choices
available, and the Telnet session will automatically terminate at that time. If no
automatic termination is needed, select “No idle disconnect timeout.”
When finished in this screen, click Apply to activate any changes made.