VocoPro CDG-8800PRO - Manual (Page 14)

12
Operations
Auto-Cue Title Screen
Using the Cue button while in SINGLE mode allows you to cue a track to pause while showing the song’s title screen
on the TV or monitor.
• Make sure the CDG-8800 is in SINGLE mode.
• Press the CUE button to enter Auto-Cue mode.
• Use the |<< and >>| buttons to select the desired track.
• Wait a few seconds for the title screen to appear.
• The song’s title screen will remain until you press PLAY, then the song will begin
Frame search
• While the disc is paused, turn the JOG DIAL to skip ahead or backwards one frame at a time. The LCD display will
show the time on the track.
• Press the PLAY/PAUSE button to start playing at the selected time.
• Clockwise skips ahead and counter-clockwise skips backwards.
Scanning (Fast forward/Fast backward)
• Turn the shuttle dial clockwise to scan in the forward direction or counterclockwise to scan in the
reverse direction.
• This unit supports 3 different speeds based on the rotating angle of the SHUTTLE.
Matching the Beats Per Minute (BPM)
There are three tools available for matching the BPM of the two CDs:
• Use the pitch slider to adjust the BPM.
• Use the PITCH BEND buttons to change the BPM temporarily.
• Turn the JOG dial to change the BPM temporarily.
Program play
• Press the PROGRAM button, the player will enter the program mode and the CD will stop rotating.
• Select the desired track by pressing the SKIP button, then press the PROGRAM button again. The selected track
will be added to the program sequence.
• Repeat step 2. A maximum of 20 tracks can be programmed at one time.
• Press the PLAY/PAUSE button to start the program play from the first selection.
• Press the program button again during program play to stop play.
• Press and hold the program button more than 2 seconds to cancel the program mode and erase all the current
program contents.
Loop Play
• Press the LOOP button to set the loop start point A, the LOOP indicator will flashes on the LCD.
• Press the LOOP button again to set the loop end point B, after the B point is set, the playback will enter the loop play
from A to B repeatedly.
• Press the LOOP button again, the loop play function is canceled, the LOOP indicator goes out.