Vision Fitness R2000 - Manual (Page 7)

7
4
STEP
• Slide the mast cover onto the
console mast.
• With the included wire tie, pull the
console cable, or sensor wire, through
the console mast. Place the console
mast into the console mast mounting
bracket. Secure the mast to the
bracket with 5 screws (M8x15L) and
lock washers (M8) and tighten with
the 5
MM Allen wrench. NOTE: The
screw facing the seat does not use a
lock washer. Tighten this screw only
until snug. Slide the console mast
cover down over the screw heads.
• R2000 ONLY: Turn the tension knob
to level 16. Direct the cable on the
tension knob through the tension knob
bracket. Attach the cable to the
tension cable located in the console
mast. Secure the tension knob to the
console mast with the washer (M5)
and screw (M5x70L). Tighten with
Phillips screwdriver.
• Remove the four screws from the
back of the console. Plug the wire
harness into the console (For R2000
plug in RPM Sensor wire also). Mount
the console onto the console mast with
the four screws.
• R2000 ONLY: Secure the water
bottle bracket to the console mast with
the 4
MM L-shaped wrench and two cap
screws (M5x35L). Attach the water
bottle cage to the bracket with two
screws (M5x15L) using the
screwdriver. Insert the water bottle into
the cage.
• R2100 ONLY: Attach the water
bottle to the console mast with two
screws (M5x15L) using the
screwdriver. Insert the water bottle into
the cage.
GREEN BAG
4
STEP R2000
R2100