Williams Sound WIR 239 - Manual (Page 10)

®
10
S
ETTING UP THE
RX237 R
ECEIVER
S
TEP
1: I
NSTALL THE
R
ECEIVER
B
ATTERIES
Insert the rechargeable battery into the bottom of the RX237 Receiver
(see page 12). Place the receiver into the charger cradle built into the
top of the TX238 Transmitter and let charge overnight. The spare bat-
tery can be plugged into the charging port located on either side of the
transmitter. By keeping the spare battery charged, you can easily swap
batteries when the one in use runs out and always have a fresh battery
ready. A fully charged battery will operate the receiver for approxi-
mately 6 hours depending on the volume setting. The battery should
be changed when you notice the sound getting weak and noisy. the
batteries may be left charging when not in use.
S
TEP
2: U
SING
T
HE
WIR RX237 R
ECEIVER
The RX237 will automatically configure itself for stereo or mono
(2.3 or 2.8 MHz) operation depending on the setup chosen for the
TX238 Transmitter.
Before you use the system, double check to make sure the WIR
TX238 Transmitter’s power supply is plugged in. Make sure the TV,
stereo, or audio source is turned ON. Make sure the receiver’s battery
is fully charged.
To Use the Receiver:
1. First, place the lanyard on the receiver around your neck.
IMPORTANT: a dual detector infrared “eye” is located in the
front of the receiver. Do not cover it up or you will lose reception.
Make sure the “SOUND PLUS” lettering is facing away from
you when you put the receiver on.
2. Next, plug in an earphone, headphone, or neckloop with 3.5mm
plug into the jack on the bottom of the RX237 receiver (see drawing
on page 12). Note: The RX237 turns ON automatically when you
plug in the earphone/headphone into the jack, and turns OFF when
you remove the earphone/headphone from the jack.
3. Rotate the volume control to a comfortable listening level. Note: If
you are using a neckloop with the RX237, turn the volume control to
“2,” or about half of full volume. Then, turn the switch on your hear-
ing aid to the “T” position and adjust the volume to a comfortable
listening level. If the sound is weak, increase the volume on the
RX237 Receiver, then on your hearing aid.