Weider Pro 2250 - Manual (Page 12)

12
22. Press a 1 1/2” Square Inner Cap (32) into the
Seat Frame (36).
Insert the 1/4” x 2” Carriage Bolt (38) into the
center hole in the Seat Plate (37). Attach the Seat
Plate to the Seat (13) with two 1/4” x 3/4” Screws
(18).
Insert the 1/4” x 2” Carriage Bolt (38) into the indi-
cated hole in the Seat Frame (36). Tighten a 1/4”
Nylon Locknut (2) with a 1/4” Washer (10) onto
the Carriage Bolt.
Attach the other end of the Seat (13) to the Seat
Frame (36) with a 1/4” Washer (10) and a 1/4” x
2” Screw (24).
23. Press a 1 1/2” Round Inner Cap (77) into the Leg
Lever (29).
Lubricate the 5/16” x 2 1/2” Bolt (80). Attach the
Leg Lever (29) to the Seat Frame (36) with the
Bolt and a 5/16” Nylon Locknut (3). Do not over-
tighten the Locknut; the Leg Lever must be
able to pivot freely.
Insert a 3/8” x 2” Eyebolt (35) into the Leg Lever
(29) from the direction shown. Tighten a 3/8”
Nylon Locknut (21) and a 3/8” Washer (9) onto
the Eyebolt.
24. Press two 3/4” Round Inner Cap (34) into the
ends of a Pad Tube (28). Insert the Pad Tube into
the Seat Frame (36). Slide two 5 1/2” Pads (30)
onto the Pad Tube.
Assemble the other Pad Tube (28) to the Leg
Lever (29) in the same manner.
25. Rest the Seat Frame (36) on the indicated pin in
the Front Upright (42). Attach the Seat Frame to
the Front Upright with a 5/16” x 2 3/4” Carriage
Bolt (14) and the Seat Knob (40).
22
80
Lubricate
77
35
21
9
29
23
3
36
24
25
30
30
29
34
34
28
28
36
10
2
24
36
13
38
37
32
18
36 40
Pin
42
14