Weider Pro 2250 - Manual (Page 9)

9
11. Note: The 3 1/2” Pulley (15) in this step has
been preassembled. It is shown exploded in
this drawing for clarity.
Route the Short Cable (58) around the 3 1/2”
Pulley (15). Make sure that the Cable Trap (66)
is turned to hold the Cable in the groove of
the Pulley. Tighten the 3/8” x 3 1/2” Bolt (16), the
3/8” Washer (9), and the 3/8” Nylon Locknut (21).
12. Route the Short Cable (58) under a 3 1/2” Pulley
(15). Attach the Pulley and a Cable Trap (66) to
the upper hole in the Front Upright (42) with a
3/8” x 3 3/4” Bolt (71), a 3/8” Washer (9), and a
3/8” Nylon Locknut (21). Make sure that the
Cable Trap is turned to hold the Cable in the
groove of the Pulley.
13. Remove the preassembled 3 1/2” Pulley (not
shown) from the Long “U”-bracket (57).
Attach the end of the Short Cable (58) to the
Long “U”-bracket (57) with a 1/4” Nylon Locknut
(2) and a 1/4” Washer (10). See the inset draw-
ing. Do not overtighten the Locknut; it should
be threaded onto the end of the Cable so that
two threads are showing above the nut.
14. Note: The 3 1/2” Pulley (15) in this step has
been preassembled. It is shown exploded in
this drawing for clarity.
Locate the Long Cable (23). Route the Long
Cable over a 3 1/2” Pulley (15). Make sure that
the Cable is between the Pulley and the hook
and that the end of the Cable with the ball is
on the indicated side of the hook. Tighten the
3/8” x 3 3/4” Bolt (71) and the 3/8” Nylon Locknut
(21).
14
11
12
13
57
23
15
Hook
Ball
71
21
58
55
21
66
15 58
17
9
16
2
10
21
58
42
15
66
71
9
58
57
2
10