Weider Pro 2250 - Manual (Page 8)

8
8. Identify the Right Arm (48) and the Left Arm (47)
by the position of the welded bracket on each Arm.
Press a 2” Round Inner Cap (33) into the lower
end of the Left Arm (47). Wet the end of the Arm
with soapy water and slide a 10” Pad (45) onto it.
Make sure the 1 1/8” x 2 1/2” Plastic Bushing (74)
is in the Arm.
Lubricate both axles on the Top Frame (55). Have
another person slide the Left Arm (47) onto the
left axle on the Top Frame. Note: Be careful not
to confuse the Right Arm (48) with the Left
Arm. Make sure that the upper end of the Left
Arm is behind the indicated bracket on the
Top Frame.
Set two 1” Retainers (69) on top of a 1” Round
Cover Cap (70). Make sure that the teeth on the
Retainers bend toward the Cover Cap, as
shown in the inset drawing. Tap the Retainers
and Cap onto the Left axle on the Top Frame (55).
Attach the Right Arm (48) in the same manner.
9. During steps 9 through 20, see the CABLE
DIAGRAMS on page 17 of this manual to verify
proper cable routing.
Locate the Short Cable (58). Lay the Cable in
the bracket on the Base (4) and under the Press
Frame (17). Attach a 3 1/2” Pulley (15) to the
bracket with a 3/8” x 2” Bolt (12) and a 3/8” Nylon
Locknut (21). Make sure that the end of the
Cable with the ball is on the indicated side of
the bracket.
10. Route the Short Cable (58) under a 3 1/2” Pulley
(15) Attach the Pulley and a Cable Trap (66) to
the lower hole in the Front Upright (42) with a 3/8”
x 3 3/4” Bolt (71), a 3/8” Washer (9), and a 3/8”
Nylon Locknut (21). Make sure that the Cable
Trap is turned to hold the Cable in the groove
of the Pulley.
9
10
47
33
70
69
74
48
55
Bracket
Lubricate
Axle
15
17
21
12
4
Bracket
21
58
58
42
15
66
71
9
45
8
69
55
70
Cable Assembly