Wolf Appliance Company High Definition Video Processor DCL-200FD - Manual (Page 30)

29
Step 2] Press the INFO button.
The Device LED will blink number of times indicating the number of each digit of the Setup Code number. Each digit is
separated by 1 second interval of the LED being turned off.
For example: One blink, three blinks and eight blinks indicate the code number 138.
Tip: Ten blinks are equal to the number “0”.
2 Programming the remote with Learning Method
All buttons in 7 Device modes can learn except the LIGHT button.
-. Learning available carrier frequency is from 15KHz to 480KHz.
-. Learned functions override any existing preprogrammed functions on the remote control.
-. Learned functions are automatically erased when a new function is learned on the same button.
-. Learned functions are retained even after a different Setup Code number is programmed into the remote control.
-. To return to an original preprogrammed function, a learned functioned should be erased.
A. Learning a New Command
Step 1] Press the Source Device Input button and the ENT buttons simultaneously and hold for 3 seconds until the
Device LED turns on. (The LED will stay on for 20 seconds. The next step must be entered during this period).
Step 2] On the remote control, press the button that is to be taught the new command. (The Device LED will blink one time).
Step 3] On the original remote control, press and hold the button for the command to be learned until the Device LED
blinks twice.
Tip: The LED will flash 5 times if there is error in process of learning. Please repeat Step 2 and Step 3.
Repeat Step 2 and Step 3 for any other buttons to be taught in the Device mode selected in Step 1.
Step 4] Once you have completed learning new commands to buttons in the selected Device mode, press and hold the
Source Device Input button and ENT button simultaneously to save learned functions. The Source Device
Input button LED will blink three times to confirm the programming.
Please repeat for any other Device modes starting from Step 1.
B. To Erase a Learned Command From a Button
Step 1] Press the Source Device Input button and the ENT buttons simultaneously and hold for 3 seconds until the
Device LED turns on. (The LED will stay on for 20 seconds. The next step must be entered during this period).
Step 2] On the remote control, press the button that is to be erased for 3 seconds. (The Device button LED will blink
twice to confirm it).
Repeat Step 2 for any other buttons to be erased in the selected Device mode.
Step 3] To exit this feature, press and hold the Device button and the ENT button simultaneously, once again. (The LED
will blink three times).
ProScaler