Wolf Appliance Company High Definition Video Processor DCL-200FD - Manual (Page 37)

36
Component Input
Component Input menu gives you control over the analog component inputs. To use this control, you must select Component 1
or Component 2, otherwise, this menu item will be grayed out.
The Component Inputs window gives you 3 options for controlling Automatic Gain Control on Analog Inputs:
Single Sync: This is the default setting. Most component inputs will have sync on the Y signal and should use Single Sync.
Triple Sync: A few devices will add sync to all three component input signals (Y, Pb, Pr). In you know your device does this,
choose Triple Sync.
AGC Disable: This choice disables Automatic Gain Control. In some cases, AGC will cause brightness levels to be incorrect
due to distortions in the analog input signals. Disabling AGC may correct this problem. You probably don’t know if a device
that generates an analog component signal puts sync on Y, or on all three inputs, or if it distorts the incoming signal. In general,
it may be best to use Single Sync. If your picture does not look correct, experiment with the other settings.
Hot Plug Source
Hot Plug Source is a new feature that improves compatibility with certain source components that connect to the ProScaler
through an HDMI input.
When Hot Plug Source is enabled for an HDMI input, a signal on the HDMI input connector, called Hot Plug, is toggled when
switching to that input. Toggling Hot Plug causes the source component and ProScaler to perform an HDCP re-authentication.
HDCP is a copy protection technology that is part of the HDMI standard.
Enable Hot Plug Source if you experience problems switching to a particular source component. These problems can include
very slow switching with flashing on the screen, or colored noise over the entire screen. Two common components that
benefit from enabling Hot Plug Source are the Sony PS3 game console and the Oppo 970 DVD player.
Hot Plug Source can be independently enabled for each HDMI input. To enable Hot Plug Source, first select an HDMI input,
then select the Hot Plug Source window.
To enable Hot Plug Source, first select an HDMI input, then go to the menus to the window shown above, and select ON.
If you are unsure whether Hot Plug Source will help, then you should go ahead and enable it. The only downside to enabling
Hot Plug Source is that switching could be a little slower due to the time it takes to re-authenticate.
ProScaler
High Definition Video Processor User’s Manual