Wolf Appliance Company High Definition Video Processor DCL-200FD - Manual (Page 31)

30
C. To Erase All the Learned Commands in One Device Mode
Step 1] Press the Source Device Input button and the ENT buttons simultaneously and hold for 3 seconds until the
Device LED turns on. (The LED will stay on for 20 seconds. The next step must be entered during this period).
Step 2] Press the Source Device Input and Pause buttons simultaneously and hold for 5 seconds until the LED blinks
two times.
Step 3] To exit this feature, press and hold the Source Device Input button and the ENT button simultaneously, once
again. (The LED will blink three times).
3 Programming the remote with Advanced Functions
A. Programming Multi Commands to Macro Buttons
There are nine (7 for R5) Macro buttons (ON, System Off and 7 (5 for R5) Device buttons) that are designed to store up
to 20 commands in each button.
Pressing any one of the Macro button will send out the series of commands that are stored in the button. For example,
you either turn on or off several devices at a time by storing Power On/Off commands to these buttons.
Step 1] For programming Macro Commands on a Device button, press the Source Device Input and the MUTE buttons
simultaneously and hold for 3 seconds until the Device LED turns on. (The LED will stay on for 20 seconds. The
next step must be entered during this period).
For programming Macro Commands on the POWER ON or SYSTEM OFF button, Press the POWER ON or SYSTEM OFF
button and the MUTE buttons simultaneously and hold for 3 seconds until the TV and SAT/CABLE Devices LED turns on.
(The LED will stay on for 20 seconds. The next step must be entered during this period).
Step 2] Press one of the Macro buttons.
Step 3] Press in up to 20 buttons you wish to store in the Macro. (The Device LED will blink once for each button pressed).
Tip: Pressing a Device button to change device modes is considered as one command.
Step 4] Press the Channel UP button to save the selection. (The LED will blink three times to confirm the programming).
Note: You can program delays in between commands by pressing the PAUSE button. Each press add half a second to
the delay.
Note: If you add the delay time at the first step of macro commands, the remote will send the macro commands once
you pressed the Macro button for 2 seconds. (Press & Hold Function).
Note: You cannot program the CH + and PAUSE buttons as a macro command.
ProScaler
High Definition Video Processor User’s Manual