Watlow Electric Ramping and Profiling Microprocessor-Based Control SERIES 1500 - Manual (Page 66)

Technical Reference
Walt Step- STP?
*=Unprogrammed parameter
0 0 0 3 ---.- - - - . - - - - -
l
***
Step Wait For Wait_ Wait For
Type . Ch-1
Ch-2 Event
Sample Response:
0003 1234 0840 0001
l
**** 0015 0010 0030
STP Program a step.
---- ---- ----
Wait For Wait For wait For
Minutes
Real Time
The first
parameter entered after the step number is the Step Type.
00 = Blank Step
01 = Set Point Step
02 = Jump Loop Step
0 3 = Wait For Step
Note:
Whenever you send an STP
command (to enter Step parameters) the Series 1500 haIts
automatically.
Blank Step - STP
. = Unprogrammed parameter
-- 00 l l l l l l l
S t e p Ch1-Set Ch-2 Set Ch-1 Ch-2 Hr. Mn. Sec.
# Type Point P o i n t Events Events Duration of the step
Sample Transmission:
STP2200*******
or
STP 22 00
Set Point Step - STP
Step
I
Step Ch-1 Set Ch--2 set Ch-1 Ch-2 Hr. Mn. Sec.
Type Point Point Events Events Duration Of The step
SampIe
Transmission:
STP 1201 1234 0820 00 03 01 25 00
Note:
Enter
Event (Auxiliary) Outputs ON/OFF for Ch-1 and Ch-2 per NOTE with “MNTR?” on p. 60.
WATLOW Series 1500 User's Manual
Data Communications, Commands and Syntax, Chapter 4
0001 — — —.— — — — . — — — — — — — — — — — — — — — — — — —
Step
**** **** **** **** ****
-99 -99 3200 °F