Weider Pro 208 - Manual (Page 6)

6
1. Before assembling this product, make sure you
have read and understand the information in the
box above.
Insert a 1 3/4” Slotted Square Inner Cap (50) into the
Bench Frame (5).
Place the Bench Frame (5) in the bracket (A) on the
Front Leg (4) and attach it with three M8 x 16mm
Bolts (39) and three M8 Washers (21). Do not fully
tighten the Bolts.
Note: The Caps mentioned in all assembly steps
may come pre-assembled from the factory.
1
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two people.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• For help identifying small parts, use the PART
IDENTIFICATION CHART on page 5.
• As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
The following tools (not included) are required
for assembly:
• Two (2) adjustable wrenches
• One (1) rubber mallet
• One (1) standard screwdriver
• One (1) phillips screwdriver
• Lubricant, such as grease or petroleum jelly
plus soapy water.
Assembly will be more convenient if you have the
following tools: A socket set, a set of open-end or
closed-end wrenches or a set of ratchet wrenches.
Assembly
Make Things Easier for Yourself!
Everything in this manual is designed to ensure
that the weight bench can be assembled suc-
cessfully by anyone. However, it is important to
recognize that the weight bench has many
small parts, and that the assembly process will
take time. Most people find that by setting aside
plenty of time, and by deciding to make the task
enjoyable, assembly will go smoothly.
39
5
4
21
39
A
39
50
21
2. Press a 2” Square Inner Cap (29) into the lower end
of the Left Upright (8).
Attach the Left Upright (8) to the Left Base (6) with a
Support Plate (28), two M8 x 65mm Bolts (42) and
two M8 Nylon Locknuts (40). Do not confuse the
Left and Right Upright. Locate the welded nut to
identify each Upright.
Do not tighten the Nylon Locknuts yet.
2
28
29
8
Welded Nut
6
42
40