Wegener Communications IPUMP 562 - Manual (Page 34)

Operation
24 800092-01 Rev. A www.wegener.com
LAN IP Networking
Carrier Settings
Terminal options
User Relay
Date and Time information
Unit Label settings
Switch Application
Set Video Decoder options
Set Decoder Options
Use following steps to display Decoder Setup screen on the OSD menu:
1. Navigate to the Unit Setup screen, see Unit Setup screen on page 23.
2. Press the down arrow button to select Decoder Setup .
3. View the details as shown in Figure 3.13 .
Figure 3.13: iPump 562 OSD Decoder Setup
Use the Decoder Setup screen to set and display the decoder options.
Table 3.7: Video Decoder Options
Option Possible values Comments
Decoder Source Follow Tune (currently selected
RF source and program #) or Off
(no A/V output) Controls source of input transport stream for the
primary A/V decoder to play. The source can be either
Multicast UDP from Satellite/RF or Multi/Unicast UDP
from LAN/ETHERNET
TV Aspect Ratio 4x3 (Traditional TV) 16x9 (Wide
screen TV) 14x9 (CiniView II) Allows the receiver to automatically correct a mismatch
in the aspect ratio of the TV to the content being
displayed.
Output Scaling Letterbox (black bars either at
top/bottom or at sides), Pan/Scan
(display may be off screen) Optimizes viewing quality if the content does not match
the TV Aspect Ratio. In Pan/Scan mode, improvement
in viewing experience depends on the source content.
Closed Captioning PASSTHRU (ntsc/pal) or CC1:4
(EIA-608) orDTV (EIA-708-B) Sets the option to render subtitling information in
different formats including Divicom.