Wasp Bar Code Wasp WPL305 - Manual (Page 7)

Lower Cover
Figure 5: Pull the lever to open the cover
3. Place the roll of labels onto the center of the paper roll mount.
Printer Top Cover
Paper Roll Mount
Support Bar
Paper Guide
Teflon Bar
Top Cover Open Lever
Figure 6: Label installation
4. Feed the paper, printing side face up, under the Teflon bar and the paper
guide and pass over the platen.
5. Adjust the yellow center-biased paper guides to slightly touch the edges of
the label backing.
6. To close the printer top cover, lift the cover to the ultimate open angle then
use both hands to close the cover gently. C lose the printer top cover slowly
and make sure the cover locks latch securely.
Note:
1. Make sure hands are not placed in the printer when close the top
5