Leanup, Continued – Wagner SprayTech Model 9140 User Manual
Page 11
© 2003 Wagner Spray Tech - All rights reserved.
11
Customer Service: 800-880-0993
English
C
LEANUP
(
CONTINUED
)
1. Make sure the pump is switched OFF (O), the
PRIME/SPRAY knob is turned to PRIME, and unplug the
sprayer.
2. Remove spray gun from the paint hose using adjustable
wrenches.
3. Remove filter from spray gun (refer to Cleaning the
Spray Gun Filter, page 9).
4. Remove spray tip from spray guard assembly.
Continue cleaning instructions on next column
Housing
Filter
Trigger
guard
GX-08/10
Filter
Spring
Fitting
Housing
GX-06/07
o
5 Clean spray tip and filter with a soft-bristled brush and the
appropriate cleaning solution. Be sure to remove and
clean the washer and saddle seat located in the rear of
the spray tip assembly.
6. Reassemble spray gun:
• install gun filter tapered-end first, and
• install spray tip, saddle seat and washer, and replace
spray guard assembly.
7. Thread the spray gun back onto the paint hose. Tighten
with a wrench.
IMPORTANT!
If you used oil-based paints, you must flush the pump
again using warm, soapy water to prepare it for
storage. Repeat Cleaning the Suction Set instructions.
Housing
Filter
Trigger
guard
GX-08/10
Filter
Spring
Fitting
Housing
GX-06/07
Washer
Saddle
seat
C
LEANING THE
S
PRAY
G
UN
F
ILTER AND
T
IP
A
SSEMBLY