Western Digital WDE2170 - Manual (Page 39)

WD Enterprise WDE2170/WDE4360 SCSI Connectors
4079-001045 Rev. B RELEASED 04-08-97 31
6. SCSI C ONNECTORS
6.1. Power Connectors and Cables
Table 6-1. 50-pin Drive Power Connector and Cable
POWER CONNECTOR MATING CONNECTOR WIRE GAUGE
AMP 2-in-1 1x4 PC power connector 18 AWG
Table 6-2. 68-pin Drive Power Connector and Cable
POWER CONNECTOR MATING CONNECTOR WIRE GAUGE
Molex 3-in-1 combo (or equivalent) 1x4 PC power connector 18 AWG
6.2. SCSI Physical Interface
All Western Digital SCSI hard drives are designed to conform to the SCSI-3 Parallel
Interface as described in the draft of proposed ANSI specification X3T10/855D Revision
15a. In addition, drives equipped with the 80-pin SCA connector are designed to
conform to the Small Form Factor Committee draft specification SFF-8046 Rev 2.0
entitled “SCA-2 (Single Connector Attach) for SCSI Disk Drives”. Since tutorials on
SCSI-3 and SCA are beyond the scope of this manual, users should review their SCSI
implementations as required to ensure compliance. The SCSI-3 spec has several
informative annex sections on cabling, bus termination, crosstalk, etc., that are quite
helpful to SCSI system architects and implementors.