Weider WESY26331 - Manual (Page 15)

15
31. Route the Press Cable (88) over a 90mm Pulley
(82). Attach the Pulley and a Cable Trap (80) to
the lower hole in the Pulley Plates (31) with an
M10 x 48mm Bolt (50) and the M10 Nylon
Locknut (42).
The Cable must be routed from
the direction shown. Make sure that the Cable
Trap is positioned to hold the Cable in place.
32. Route the Press Cable (88) under a 90mm Pulley
(82). Attach the Pulley and a Cable Trap (80) to
the Leg Press Upright (4) with an M10 x 92mm
Bolt (76), an M10 Washer (38) and an M10 Nylon
Locknut (42).
Make sure that the Cable Trap is
turned to hold the Cable in place.
33. Route the Press Cable (88) over a 90mm Pulley
(82). Attach the Pulley and a Cable Trap (80) to
the indicated hole in the Press Frame (12) with
an M10 x 82mm Bolt (66), an M10 Washer (38),
and the M10 Nylon Locknut (42).
34. Wrap the Press Cable (88) around a “V”-pulley
(81). Attach the “V”-pulley to the upper bracket
on the Leg Press Upright (4) with an M10 x
57mm Bolt (91) and an M10 Nylon Locknut (42).
32
33
34
31
31
31
42
82
50
88
80
82
88
66
38
88
12
82 80
42
88
81
4
91
42
38
42
4
80
76