Weider WESY26331 - Manual (Page 20)

50. Locate and open the parts bag labeled “SEAT
ASSEMBLY.”
Attach the Small Backrest (18) to the Ab Upright
(1) with two M6 x 63mm Machine Screws (64)
and two M6 Washers (37).
51. Insert an M6 x 52mm Carriage Bolt (61) through
the center hole in a Seat Plate (41). Attach the
Seat Plate to a Seat (17) with two M6 x 16mm
Screws (59).
Insert the M6 x 52mm Carriage Bolt (61) through
the indicated hole in the Rear Seat Frame (16).
Thread an M6 Nylon Locknut (44) and an M6
Washer (37) onto the Carriage Bolt.
Attach the other end of the Seat (17) to the Rear
Seat Frame (16) with an M6 Washer (37) and an
M6 x 52mm Machine Screw (63).
Tighten the M6
Nylon Locknut (44).
52. Lubricate the M8 x 60mm Bolt (62) with grease.
Attach the Leg Lever (15) to the Rear Seat Frame
(16) with the Bolt and an M8 Nylon Locknut (40).
Do not overtighten the Locknut; the Leg Lever
must pivot freely.
Insert the Eyebolt (79) into the Leg Lever (15)
from the direction shown. Tighten an M10 Nylon
Locknut (42) and an M10 Washer (38) onto the
Eyebolt.
53. Rest the slot in the Rear Seat Frame (16) on the
indicated post in the Ab Upright (1). Attach the
Rear Seat Frame to the Ab Upright with an M8 x
70mm Carriage Bolt (77) and the Seat Knob (30).
53
50
51
52
20
SEAT ASSEMBLY
Slot
44
63
17
16
41
61
59
1
18
Post
1
77
16
30
16
Lubricate
62
42
38
40
15
79
37
64
37