Weider WESY26331 - Manual (Page 7)

4. Slide the Front Seat Frame (8) onto the indicated
M8 x 63mm Carriage Bolts (49) in the Press Base
(13). Hand tighten two M8 Nylon Locknuts (40)
onto the Carriage Bolts.
Do not tighten the
Locknuts yet.
Attach the other end of the Front Seat Frame (8)
to the Leg Press Upright (4) with two M8 x 67mm
Bolts (55), two M8 Washers (20), and two M8
Nylon Locknuts (40).
Do not tighten the
Locknuts yet.
5. Insert two Weight Guides (23) into one of the
brackets on the Weight Base (14).
Make sure the
Weight Guides are oriented with the tall holes
near the top (see the inset drawing). Attach the
lower ends of the Weight Guides to the Base with
an M8 x 152mm Bolt (67), two 13mm x 19mm
Spacers (69), and an M8 Nylon Locknut (40).
Do
not overtighten the Locknut.
Attach the other Weight Guides (23) in the
same manner.
6. Slide a Weight Bumper (27) onto each of the
Weight Guides (23).
Slide eight Weights (90) onto each set of Weight
Guides (23).
Make sure that the pin grooves
are on the indicated side of each stack of
Weights.
7. Press a Weight Tube Bumper (26) into each
Weight Tube (25).
Insert a Weight Tube (25) into each stack of
Weights (90).
Make sure that the pins on the
Weight Tubes are in the pin grooves in the
upper Weights.
7
6
7
90
90
Pin
Grooves
27
27
23
23
26
25
Pin
Grooves
90
Groove
90
5
67 69
23
Tall
Hole
23
40
14
4
55
20
49
40
8
40
4
13