Weider 740 - Manual (Page 18)

18
Tightening the Cables
Woven cable, the type of cable used on the home gym
system, can stretch slightly when it is first used. If there
is slack in the Cables before resistance is felt, the
Cables should be tightened.
To tighten the Cables, insert the Weight Pin (26, not
shown) between the third and the fourth Weight, count-
ing from the top. See “Changing the Weight Setting” on
page 17 for instructions on moving the Weight Pin.
Tighten the 3/8” Plain Nut (56) a few turns further onto
the 3/8” Eyebolt (35) and then tighten the 3/8” Nylon
Jamnut (22) securing the Eyebolt to the Leg Lever (29).
Repeat this procedure until the Cables feel tighter.
35
56
29
22
Trouble-shooting and Maintenance
Inspect and tighten all parts each time you use the weight system. Replace any worn parts immediately.
The weight system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use sol-
vents.
Additional slack can be removed by moving the upper
3 1/2” Pulley (15) attached to the “I”-Plates (20) to the
lower hole. To do this, remove the 3/8” x 2” Bolt (12),
Cable Trap (66) and 3/8” Nylon Locknut (21). Move the
Pulley and re-attach it with the Bolt, Cable Trap and
Locknut. Make sure the Cable Trap is oriented as
shown.
Note: If a Cable tends to slip off the Pulleys often,
the Cable may have become twisted. Remove the
Cable and re-install it.
If the Cables need to be replaced, see ORDERING
REPLACEMENT PARTS on the back cover of this
manual.
12
21
20
66
15