Weider 740 - Manual (Page 7)

7
3. Attach the two Weight Bumpers (19) to the Stabilizer
(5) with two #8 x 1” Screws (18).
Slide the six Weights (25) onto the two tubes on the
Weight Guide (62).
Note: Make sure all of the Weights are turned so
the pin grooves are on the same side and that the
grooves are oriented as shown in the drawing.
3
19
19
18
18
5
62
25
Pin
Grooves
4. Press the Weight Tube Bumper (64) into the end of
the Weight Tube (63).
Insert the Weight Tube (63) into the stack of Weights
(25).
Lubricate the insides of the holes in the Top Weight
(67).
With the slot facing down, slide the Top Weight (67)
onto the two tubes on the Weight Guide (62) and set
it on the stack of Weights (25).
4
67
63
25
64
Slot
5. Place the Top Frame (55) on top of the Upright (42)
as shown. Insert a 5/16” x 2 1/4” Bolt (1) with a 5/16”
Flat Washer (8) through the Top Frame and the
bracket on the support frame. Finger tighten a 5/16”
Nylon Locknut (3) onto the Bolt.
Hold the Large Pulley Bracket (40) on the Top Frame
(55). Make sure that the Large Pulley Bracket is
turned as shown. Attach the Large Pulley Bracket
and the Top Frame to the Upright (42) with two 5/16”
x 2 1/4” Bolts (1) and two 5/16” Nylon Locknuts (3).
Do not tighten Nylon Locknuts(3) yet.
5 1
1
3
3
40
55
1
Long end of bracket
must be on this side
8
42
Support
Frame