Weider WEBE19710 - Manual (Page 5)

5
2
7
20
8
25
26
26
2. Attach the Foot Plate (8) and the Weight Base
(20) to the Center Base (7) using two M10 x
78mm Bolts (25) and two M10 Nylon Locknuts
(26).
Do not tighten the Nylon Locknuts yet.
1
1. Press 60mm Square Outer Caps (19) onto the
ends of the Right and Left Bases (5, 6).
Attach the Right and Left Bases (5, 6) to the
Center Base (7) using four M10 x 78mm Bolts
(25) and four M10 Nylon Locknuts (26).
Do not
tighten the Nylon Locknuts yet.
19
5
25 7
25
6
19
19
26
26
19
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two people.
• For help identifying small parts, use the PART
IDENTIFICATION CHART on page 14.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the weight rack, make sure all
parts are oriented as shown in the drawings.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
The following tools (not included) are required
for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
• Lubricant, such as grease or petroleum jelly,
and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Things Easier for Yourself
This manual is designed to ensure that the
weight rack can be assembled successfully by
anyone. Most people find that by setting aside
plenty of time, assembly will go smoothly.
ASSEMBLY