Weider WEBE19710 - Manual (Page 7)

7
7
9. Press Weight Carriage Bushings (22) into the top
and bottom of the Weight Carriage (13). Press a
2” Round Inner Cap (36) into each end of the
weight tube on the Weight Carriage.
25
25
8
38
23
26
9
36
Weight Tube
36
22
22
13
30
25
9
4
3
26
26
26
24
20
21
11
Hole
10
26
13
40
26
11
25
Bracket
10. Insert the M10 x 19mm Bolt (40) into the bracket
on the Weight Carriage (13). Slide the Weight
Carriage onto the Weight Guide (11).
Be sure the
Weight Carriage is turned so that the bracket
is at the top on the side shown.
Attach the Weight Frame (10) to the Weight
Guide (11) with two M10 x 78mm Bolts (25), two
M10 Washers (24), and two M10 Nylon Locknuts
(26).
Attach the Weight Frame (10) to the Center Frame
(9) with two M10 x 78mm Bolts (25), two M10
Washers (24), and two M10 Nylon Locknuts (26).
Do not tighten the M10 Nylon Locknuts (26)
yet.
24
25
9
24
24
24
10
7. Attach the Center Frame (9) to the Left and Right
Frames (3, 4) with four M10 x 78mm Bolts (25)
and four M10 Nylon Locknuts (26).
Do not tight-
en the Nylon Locknuts yet.
8. Press a Weight Stop Bushing (30) into the top of
the Carriage Stop (23). Attach the Carriage Stop
to the indicated hole in the Weight Guide (11)
with an M10 x 86mm Bolt (38) and an M10 Nylon
Locknut (26).
Press a 1.5mm Thick 60mm Square Inner Cap
(21) into each end of the Weight Guide (11) (see
the inset drawing).
Attach the Weight Guide (11) to the Weight Base
(20) with two M10 x 78mm Bolts (25), two M10
Washers (24), and two M10 Nylon Locknuts (26).
Do not tighten the Nylon Locknuts yet.
21
11