Weider WEEVSY87210 - Manual (Page 12)

18. Route the Long Cable (23) around the 3 1/2”
Pulley (15) attached to the bracket on the Top
Frame (55). Tighten the 3/8” x 2” Bolt (12)
and the 3/8” Nylon Locknut (21). (Note: This
Pulley is pre-assembled. It has been
shown disassembled for easy part identifi-
cation.) Be sure that the Cable is in the
groove of the Pulley and that the Cable
and Pulley move smoothly.
19. Remove the 3 1/2” Low Pulley (88) from the
Press Frame (17). Re-attach the Pulley with a
5/8” x 9/16” Spacer (73) between the Pulley
and the Press Frame. Finger tighten the
3/8” Nylon Locknut (21).
Route the Short Cable (58) under the 3 1/2”
Low Pulley (88) attached to the lower hole in
the Press Frame (17). Be sure that the end
of the Cable with the ball is on the indicat-
ed side of the Press Frame and that the
Cable is between the Pulley and the cross-
bar on the Press Frame. Tighten the 3/8”
Nylon Locknut (21).
If the indicated 3 1/2” Pulley (15) is pre-
attached to the Front Upright (42), remove it.
Route the Short Cable (58) around the Pulley.
Attach the Pulley and two Pulley Covers (89)
to the lower hole in the Front Upright with the
3/8” Nylon Jam Nut (92), the 3/8” Washer (9)
and the 3/8” x 3 3/4” Bolt (71).
18
CABLE ASSEMBL
Y
23
21
15
12
Bracket
55
19
71
9
73
88
21
Ball
Crossbar
17
92
42
15
58
12
9
89