Weider WEEVSY87210 - Manual (Page 7)

5. Lubricate the pedal axles on the Rear Upright
(56). Slide the Left Pedal (79) onto the left
pedal axle, and the Right Pedal (78) onto the
right pedal axle. Note: Make sure that the
Pedals are on the correct sides; the slot-
ted brackets must be on the insides of the
Pedals. Hold a 1" Retainer (69) and a 1"
Round Cover Cap (70) against the end of the
left pedal axle. The teeth on the Retainer
must bend outward (see the inset drawing).
Tap the Retainer and the Round Cover Cap
onto the pedal axle. Attach the Right Pedal in
the same manner.
6. Lubricate the cylinder axles on the Rear
Upright (56). Slide a 5/8” Spacer (86) and a
Resistance Cylinder (80) onto each cylinder
axle. Be sure that the decals on the
Resistance Cylinders are facing the pedals
and that the Spacer is turned as shown in
the inset drawing. Hold a 5/8" Retainer (84)
and a 5/8" Round Cover Cap (85) against the
end of the right cylinder axle. The teeth on
the Retainer must bend outward (see the
inset drawing). Tap the Retainer and the
Round Cover Cap onto the cylinder axle.
Tap a 5/8" Retainer (84) and a 5/8" Round
Cover Cap (85) onto the left cylinder axle in
the same manner.
7. Raise the Left Pedal (79) and rest it on the
hook at the lower end of the left Resistance
Cylinder (80). The hook must be in one of the
slots under the Left Pedal.
Raise the Right Pedal (78) and rest it on the
hook at the lower end of the right Resistance
Cylinder (80). Make sure that the hooks are
in the same position under both Pedals.
8. Set two Weight Bumpers (19) onto the brack-
et on the Base (4) as shown.
Stack six Weights (25) onto the Weight
Bumpers (19). Make sure that the Weights
are turned so the pin grooves are all on
the same side.
5
6
7
7
8
25
Lubricate
Slotted
Brackets
78
56
79
69
70
85
84
80
80
86
Lubricate
56
78
79
80
Pin Groove
19
4—Bracket
70 69
56
85
84
86
56
80
FRAME ASSEMBL
Y