Weider WESY49202 - Manual (Page 8)

8
9. Attach the upper ends of the Short Weight
Guides (73) to the Top Frame (55) with an M8 x
150mm Bolt (60), two 19.5mm Spacers (61),
and an M8 Nylon Locknut (3).
Attach the upper ends of the Long Weight
Guides (62) to the Top Frame (55) in the same
manner.
10. Locate and open the parts bag labeled
“ARM ASSEMBLY.”
Make sure there is a Bushing (98) in each side
of the Stabilizer (5). Press three 50mm Square
Inner Capa (27) into the ends of the Leg Press
Arm (96).
Lubricate an M10 x 80mm Bolt (67). Attach the
Leg Press Arm (96) to the Stabilizer (5) with the
Bolt and an M10 Nylon Locknut (21). Do not
overtighten the Nylon Locknut; the Leg Press
Arm must be able to pivot freely.
Align the welded tubes on the Leg Press Plate
(95) with a set of holes in the Leg Press Arm
(96). Attach the Leg Press Plate to the Leg
Press Arm with the Press Pin (97).
11. Press a 22mm Plastic Bushing (90) onto each
welded spacer on the Press Frame (17). Slide
the Press Frame into place onto the Base (4).
Note: This will be a tight fit; the Plastic
Bushings should fit snugly over the ends of
the indicated tube in the Base. Make sure
that the pulleys are on the side shown.
Lubricate the M10 x 198mm Bolt (59). Attach
the Press Frame (17) to the Base (4) with the
Bolt and an M10 Nylon Locknut (21). Do not
overtighten the Locknut; the Press Frame
must be able to pivot easily.
11
17
Pulleys
must be on
this side
Lubricate
Welded Spacers
21
4
Tube
90
59
9
10
FRAME ASSEMBL
Y
ARM ASSEMBL
Y
61 61
3
3
60
73
62
55
27
Welded
Tube
27
67
96
21
Lubricate
97
5
98
98
95
27
60