Windsor Sweeper RRB 360 - Manual (Page 12)

12 English
Î Do NOT press the accelerator pedal.
Î Set programme switch to step 1 (driv-
ing).
Î Set main switch to "1".
ƽ
Danger
Danger of accident. If the machine does not
brake, then proceed as follows:
–
If the device does not come to a halt on
a ramp with a gradient of 2% when you
release the drive pedal, then the emer-
gency-stop button may be pressed for
safety reasons only if the mechanical
functioning of the immobilizing brake
has been checked properly before com-
missioning the device.
– Switch off the machine only after it
comes to a complete halt (on an even
surface) and call up the aftersales ser-
vice!
– Further, follow all warning instructions
for braking.
Î Release emergency-stop button by
turning.
Î Sit on the seat and set main switch to
"1".
Î Set the travel direction switch to "for-
ward".
Î Press accelerator pedal down slowly.
ƽ
Danger
– Risk of injury! While reversing, ensure
that there is nobody in the way, ask
them to move if somebody is around.
– During reverse drive, a pulsing warning
sound will be heard.
– The reverse drive speed is lower than
the forward speed for safety reasons.
Î Set the travel direction switch to "back-
wards".
Î Press accelerator pedal down slowly.
Note
Driving method
–
The accelerator pedal can be used to
vary the driving speed infinitely.
Î Release the accelerator pedal, the ma-
chine brakes automatically and stops.
Driving over fixed obstacles which are
2.0 in (50 mm) high or less:
Î Drive forwards slowly and carefully.
Driving over fixed obstacles which are
more than 2.0 in (50 mm) high:
Î Only drive over these obstacles using a
suitable ramp.
In case of overloading, the drive motor au-
tomatically switches off after a certain peri-
od. The indicator lamp "Overlaod of the
drive motor" will illuminate red as soon as
the drive motor current is limited. If the con-
trol is overheated, all drives (except for the
horn and the filter cleaning) will be switched
off.
Î Allow machine to cool down at least for
15 minutes.
Î Turn the main switch to "0" and turn it
back to "1".
ƽ
Danger
Risk of injury! If the bulk waste flap is open,
stones or gravel may be flung forwards by
the roller brush. Make sure that this does
not endanger persons, animals or objects.
ṇ
Warning
Do not sweep up packing strips, wire or
similar objects as this may damage the
sweeping mechanism.
ṇ
Warning
To avoid damaging the floor, do not contin-
ue to operate the sweeping machine in the
same position.
Note
To achieve an optimum cleaning result, the
driving speed should be adjusted to take
specific situations into account.
Note
During operation, the waste container
should be emptied at regular intervals.
Note
When cleaning surfaces, only lower the
roller brush.
Note
Also lower side brush when cleaning along
edges.
Î Set programme switch to step 2. Roller
brush is lowered. The roller brush and
the side brush will rotate.
Note
To sweep up larger items up to a height of
2.0 in (50 mm), e.g. cigarette packs, the
bulk waste flap must be raised briefly.
Raising bulk waste flap:
Î Press the pedal for the bulk waste flap
forwards and keep pressed down.
Î To lower it, take foot off pedal.
Note
An optimum cleaning result can only be
achieved if the bulk waste flap has been
lowered completely.
Î Set programme switch to step 3. Side
brushes and roller brush are lowered.
Note
Roller brush and side brush start operating
automatically.
Note
During operation, the waste container
should be emptied at regular intervals.
Note
During operation, the dust filter should be
shaken off and cleaned at regular intervals.
Î Close wet/dry flap
Î Open wet/dry flap.
Note
You can thus preven the filter system from
getting blocked.
Î Open wet/dry flap.
Note
This protects the filter from moisture.
– Switch on manual filter shake off.
Î Press Filter shake off button. The filter
will be cleaned for 15 seconds.
Note
Wait until the filter shaking process is fin-
ished and the dust has settled before you
open or empty the waste container.
Î Raise the waste container slightly and
pull it out.
Î Empty waste container.
Î Push in the waste container and lock it.
Î Empty opposite waste container.
Î Set programme switch to step 1 (driv-
ing). The side brush and roller brush are
raised.
Î Turn main key to "0" and remove it.
Note
– Once the machine has been switched
off, the dust filter is shaked automatical-
ly for approx. 15 seconds. Do not open
the machine hood during this period.
– The appliance has an automatic switch-
off function to protect the batteries from
discharging. If the appliance is not in
use (with the key switch turned on) for
longer than 30 minutes, it will switch off
automatically.
Î Turn main key to "0" and remove it.
Î Secure the wheels of the machine with
wheel chocks.
Î Secure the machine with tensioning
straps or cables.
Drive the machine
Drive forward
Reverse drive
Brakes
Driving over obstacles
Overlaod of the drive motor
Sweeping mode
Sweeping with sweep roller
Sweeping with bulk waste flap raised
Sweeping with side brushes
Sweeping dry floors
Sweep in fibrous and dry waste (such as
dry grass, hay)
Sweeping damp or wet floors
Filter dedusting
Emptying waste container
Turn off the appliance.
Transport