Whistler LASER/RADAR DETECTOR - Manual (Page 11)

RESET FEATURES/CARE & MAINTENANCE
Reset Features
All user features can be reset to factory settings.
• Remove Power from unit.
• Press and hold P/V and Quiet.
• Apply power to the unit.
• Wait for display to show “Factory Reset”.
• Release P/V and Quiet. Unit is now reset to the following
features and settings.
1. Audio to level (5).
2. Set to Highway Mode.
3. B/L to DIM-BRT.
4. Auto Quiet Mode OFF.
5. VG-2 Detection Mode OFF.
6. Voice ON.
7. POP
™ Mode ON.
8. Safety Radar OFF.
9. Full Power Up sequence.
10. Default TONE 3.
11. BATT ON.
12. TEMP ON.
13. TONE OFF.
14. TEMP to “F”.
Care And Maintenance
Do not spray water, cleaners or polishes directly onto the unit.
Keep the laser-radar lens clean for optimum performance.
Also, do not use any abrasive cleaners on the unit’s exterior.
19
VG-2 ALERTS
18
VG-2 Audio/Visual Alerts
Note: You must turn the POP feature OFF in option select mode
before it will detect VG-2.
When a VG-2 signal is detected, the detector “hides” its
own radiated signal and becomes undetectable by the VG-2.
Text message confirms detection of VG-2.
Every 30 seconds, the detector checks for a VG-2 signal. If
a VG-2 signal is still present, the unit continues to hide and
repeats the VG-2 alert. If no signal is detected, two beeps
are provided, indicating an “all clear” condition. During a
VG-2 Alert X, K, and Ka band signals cannot be received.
Having a laser/radar detector does not make you invisible or
immune to laser/radar guns. As in the case with detecting
instant-on radar, there are some circumstances that the VG-2
may detect your laser-radar detector before the laser-radar can
detect the VG-2 signal in time to hide. (Reference page 24 for
Radar Detector ‘Detector’ information.)
Alert Priority
When two or more signals are received at the same time,
the alert priority is:
1. Laser
2. VG-2
3. Speed Radar
4. Safety Radar
Example:
If X band is alerting, then suddenly a VG-2 signal is
detected, the VG-2 warning will override the X band alert.