Whistler LASER/RADAR DETECTOR - Manual (Page 9)

OPERATION
15
OPERATION
14
Aux Out
Three options can be used with this unit; LED output, Tone
output and Voice output (included).
LED - The LED will flash to indicated signal detection. The
faster the flash rate, the stronger or closer the laser/radar
signal will be. This replaces the normal audio found in other
detectors. The bright LED will catch your attention as an
audio alert may not. NOTE: when this option is selected,
volume level will not be displayed on the screen.
Tone - The Tone output provides a signal to an optional
audio module. This module will provide audio for
laser/radar signals. Use and installation
instructions will be included with this option. Volume
to this module can be adjusted using the P/V button.
Voice - Voice option is defaulted to ON in option mode.
The Voice Module not only provides voice announcements
of bands received, it also provides audio alerts for
laser/radar signals that are detected. Use and installation
instructions will be included with this option.
Memory/Beep Confirmation
All features selected (except Stay Alert and Quiet) are
retained in memory. Each time a button is pressed; one beep
confirms feature “on”, two beeps confirm feature “off”.
Audio Level Adjustment (Tone Option)
The audio levels can be adjusted high to low, or low to high,
in eight steps: (0) is no audio level, (7) the highest.
As audio level is adjusted, beeps are provided and the
display indicates volume level.
• Press and hold P/V and the volume will go to the max level (7),
then proceed to lower the volume to level (0). Continuing
to hold the P/V button will repeat the volume steps above.
Auto Level Adjustment (Voice Option - Std)
Adjust the desired volume using the voice module’s built-in
control.
Auto Quiet Mode
Auto Quiet reduces the selected audio level to level
(1) approximately 5 seconds after a radar or safety radar
signal is detected. The alert for any new signal within 20
seconds will resume at level (1). Auto Quiet does not affect
VG-2 or laser alerts.
• Press Quiet (before a signal is detected) to engage Auto
Quiet. Display shows:
• Once the Auto Quiet mode is engaged, you may cancel
the audio alarm by pressing Quiet.
• Press Quiet (when the unit is not alarming) to cancel
Auto Quiet mode.
Note: When Auto Quiet engages, it cancels the audio to the
Voice Module.
Quiet Mode
Quiet Mode cancels the optional audio during an alert and
any new alert within 20 seconds. After 20 seconds,
approximately 2 beeps are provided on any new alert and
unit then remains quiet.
• Press Quiet to cancel the audio.
• Press Quiet a second time during an alert to restore the
standard audio alert pattern; or turn the unit off, then on.