Operation 11, Operation 10 – Whistler LASER/RADAR DETECTOR User Manual

Page 7

Advertising
background image

OPERATION

11

Stay Alert™ Feature
The Stay Alert™ Feature is designed to test a driver’s
alertness. To engage (when unit is not alarming):
• Press and hold City for 2 seconds. Display shows:

Within 30-60 seconds two beeps are sounded and the B/L
flashes: to show alertness, the driver must press either the
B/L, City or Quiet button within 3-5 seconds. If the button is
pressed within 3-5 seconds, the cycle is repeated.

If the button was not pressed within 3-5 seconds, the
alarms sounds, B/L flashes and the display shows:

• Press P/V to exit.

WARNING!!! Stay Alert™ is NOT intended as a substitute
for adequate rest. You should NOT operate a vehicle if you
are drowsy. During extended periods of vehicle operation,
you should take frequent breaks. Improper reliance on the
Stay Alert™ feature may result in vehicle damage, personal
injury or death. NEVER OPERATE A VEHICLE IF YOU ARE
DROWSY.

OPERATION

10

City/City 1/City 2 Mode
Whistler’s Three Stage City Mode is designed to reduce the
annoyance of automatic door openers, intrusion alarms and
other devices which share frequencies with police radar.
Generally X band is used for these devices.

• Press City to engage City.
• Press City a second time to engage City 1.
• Press City a second time to engage City 1.
• Press City a third time to engage City 2.
• Press City a fourth time to cancel City 2 Mode and

return the unit to Highway Mode.

In City Mode, weak speed/safety radar signals give an

initial alarm of two beeps, and then remains quiet unless

the signal becomes very strong. When the signal strength
increases, two additional beeps are provided. In City 1
Mode, only the X band sensitivity is lowered. City 1 & City
2 Modes operate the same as Highway Mode, but in City
1 Mode, only the X- band sensitivity is lowered. In City 2
Mode, X-band is not detected.

CAUTION: When selecting this mode, some towns/small cities
may still be using X band radar. If Auto Quiet is engaged in City 1
or City 2 modes and the unit receives a strong radar signal, the unit
performs the Auto Quiet feature. City Modes do not change
the audio alert for laser or VG-2.

Advertising