weber SUMMIT 450 - Manual (Page 16)

16
GENERAL MAINTENANCE
11. Lift and twist the burner assembly slightly to separate
the crossover tube(1) from the burners. Remove the
burners from the cooking box.
Separate here
(1)
12. To reinstall the burners, reverse steps 3 through 11.
ƽ CAUTION: The burner openings must be positioned
properly over the valve orifices. Figure 15 (a).
Check proper assembly before fastening manifold in
place. Figure 15 (b).
Figure 15
(a)
(b)
Valve
Burner
Orifice
Crossover ® Ignition System Operations
If the Crossover Ignition System fails to ignite the Left
burner, light the Left burner with a match. If the Left
burner lights with a match, then check the Crossover
Ignition System.
• Check that both the white(1) and black(2) ignition wires
are attached properly.
• Check that the Crossover Ignition button pushes the
igniter (button) down, and returns to the up position.
• Check to see if the igniter is loose in the frame.
Tighten if necessary; See Step “Install igniter” for
correct procedure.
If the Crossover Ignition System still fails to light, Contact
the Customer Service Representative in your region using
the contact information sheet provided with your manual.
(1) (2)