weber SUMMIT 450 - Manual (Page 6)

1
3
2
1
3
2
6
Crossover Ignition System
LIGHTING
Crossover Ignition System
Summit 450
Summit 650
EACH HEAT ZONE OPERATES INDEPENDENTLY
Summary lighting instructions are on the control panel.
ƽ DANGER
Failure to open the lid while igniting the barbecue’s
burners, or not waiting 5 minutes to allow the gas to
clear if the barbecue does not light, may result in an
explosive flare-up which can cause serious bodily
injury or death.
Crossover Ignition ® System
Note - The Crossover Ignition System ignites the front
burner with a spark from the igniter electrode inside the
Gas Catcher™ Ignition Chamber. You generate the
energy for the spark by pushing the Crossover Ignition
Button until it clicks.
ƽ WARNING: Check hose before each use of
barbecue for nicks, cracking, abrasions or cuts.
If the hose is found to be damaged in any way,
do not use the barbecue. Replace using only
Weber authorized replacement hose. Contact the
Customer Service Representative in your region
using the contact information sheet provided with
your manual.
1) Open the lid.
2) Make sure all burner control knobs are turned OFF.
(Push control knob down and turn clockwise to ensure
that it is in the OFF position.)
3) Turn the cylinder on by turning the cylinder valve
counterclockwise.
ƽ WARNING: Do not lean over the open barbecue.
Keep your face and body at least one foot away
from the matchlight hole when lighting the
barbecue.
4) Select Heat Zone.
5) Push LEFT burner control knob down and turn to
START/HI.
6) Push the Crossover Ignition Button several times,
so it clicks each time.
7) Check that the burner is lit by looking through the
matchlight hole above the burner control knob.
ƽ WARNING: If the burner does not light, turn the
LEFT burner control knob to OFF and wait
5 minutes to let the gas clear before you try again
or try to light with a match.
8) After the LEFT burner is lit you can turn on the
RIGHT burner.
Note - Always light the LEFT burner first. The RIGHT
burner ignites from the LEFT burner.