Wyse Technology TM 9000 Series - Manual (Page 6)

vi
FCC Statement
This equipment has been tested and found to comply with the limits for either Class A or
Class B digital devices (refer to "Thin Client Requirements Compliance"), pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution
Changes or modifications not covered in this manual must be approved in
writing by the manufacturer’s Regulatory Engineering department. Changes
or modifications made without written approval may void the user’s authority
to operate the equipment.
Thin Client Requirements Compliance
FCC Compliance
The Models 9235LE, 9440XL, 9450XE, 9455XL, 9650XE, Model J400, Product 941GXL,
and Model x150SE, Product 9150SE Thin Clients meet Class B requirements.
IEC/EN Compliance
The Models 9235LE, 9440XL, 9450XE, 9455XL, 9650XE, Model J400, Product 941GXL,
and Model x150SE, Product 9150SE Thin Clients meet Class B requirements.
Canadian DOC Notices
Refer to the previous section, "Thin Client Requirements Compliance," to find out to which
thin client model each of the statements below refers.
Class A
This digital apparatus does not exceed the Class A limits for radio noise emissions from
digital apparatus set out in the Radio Interference Regulations of the Canadian
Department of Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites
applicables aux appareils numériques de la classe A prescrites dans le Réglement sur le
brouillage radioélectrique édicté par le Ministère des Communications du Canada.