Western Telematic Remote Power Boot Switch - Manual (Page 7)

Password: If the Password function is enabled, the unit will display a prompt. Key
in the Password and press [Enter]. If the password has not yet been defined, just
press [Enter]. 2.
Note:
The Password feature is case sensitive. ●
If you forget your password, press the Default Button when the Password
Prompt appears, then invoke the /P command to display the Password. ●
The RPB+ will display the Status Screen ( Figure 5 ).
Location: WESTERN TELEMATIC, INC.
Default: 01110
Plug Label Condition
1 PRINTER OFF
2 SERVER ONE ON
3 SERVER TWO ON
4 MODEM BANK ON
5 FAX OFF
Command Summary:
/S Status
/P Enter Parameters
/D Set Plugs to Default
/X Exit
To Switch /n s Where n = Plug #, * = All, and s = ON/OFF/BOOT
RPB+>
Figure 5: The Status Screen
3.
When the "RPB+>" prompt appears, type /P [Enter] to define system parameters.
The unit will display a series of prompts. 4.
Note:
RPB+ commands are not case sensitive. ●
To skip a prompt without changing its current definition, press [Enter]. ●
To exit from the Define Parameters function, press [Esc] at any time.
Parameters defined up to that point will be saved. ●
Location: Key in a text string that describes the RPB+ location (up to 23
characters). .
Password: The currently defined password is displayed next to the prompt. To
re-define the password (Default = [Enter]), key in the new password (up to 8
characters) and press [Enter]. The password can include blank spaces and
higher order ASCII characters. Note that the Backspace key will not function b.
RPB+; Remote Power Boot Switch -- User's Guide
file:///C|/WEBPAGE/guides/rpbp/build/rpbpguid.htm (7 of 12) [3/9/2000 5:08:10 PM]