The power-up default string – Western Telematic Remote Power Boot Switch User Manual
Page 8
during password definition.
Default (Power-Up Default): Allows the user to define default On/Off
conditions for each switched plug as described in
. Key in the
desired Power-Up Defaults and press [Enter].
c.
Echo Mode: When Echo Mode is enabled, commands sent to the RPB+ will be
echoed back to your PC or terminal, allowing keyboard entries to be displayed
by your communications program. To enable or disable the Echo Mode, type Y
or N, press [Enter], then continue with the parameter definition routine. When
the "RPB+>" prompt returns, type /D [Enter].
d.
Note:
The Echo Mode will not be enabled / disabled until the /D command is
invoked.
●
If the Default String includes invalid or missing characters, the /D
command will not function.
●
Plug Labels: Allows the user to identify the device connected to each plug
(e.g. "SERVER"). Key in the desired name (up to 16 characters) and press
[Enter].
e.
4.1. The Power-Up Default String
The Power-Up Default String allows the user to select default On/Off conditions for each
switched AC outlet. When the RPB+ is powered up, or when the /D command (Set
Defaults) is invoked, each outlet will be set according to the Default String.
Note:
The Power-Up Default String includes five characters; each character
determines the default On/Off condition for the corresponding plug. The
first character applies to Plug 1, the second character applies to Plug 2,
and etc.
●
To set a plug to default "ON" enter a one (1); to set a plug to default
"OFF", enter a zero (0).
●
If the Default String includes invalid or missing characters, plugs will be
switched "Off" when the unit is powered up, regardless of the conditions
shown by the Status Screen. In addition, the /D command will not
function.
●
RPB+; Remote Power Boot Switch -- User's Guide
file:///C|/WEBPAGE/guides/rpbp/build/rpbpguid.htm (8 of 12) [3/9/2000 5:08:11 PM]