Wasp Bar Code Wasp Duraline WLS 8400 FZ - Manual (Page 184)

WLS 8400 Product Reference Guide 8-38
Interleaved 2 of 5 (I 2 of 5)
Enable/Disable Interleaved 2 of 5
To enable or disable Interleaved 2 of 5, scan the appropriate bar code below, and select an
Interleaved 2 of 5 length from the following pages.
*
Enable Interleaved 2 of 5
Disable Interleaved 2 of 5
Set Lengths for Interleaved 2 of 5
The length of a code refers to the number of characters (i.e., human readable characters),
including check digit(s) the code contains. Lengths for I 2 of 5 may be set for any length,
one or two discrete lengths, or lengths within a specific range.
One Discrete Length - This option allows the scanner to decode only those I 2 of 5
symbols containing a selected length. Lengths are selected from the numeric bar codes
beginning on page
D-1 in Chapter D, Numeric Bar Codes . For example, to decode only I 2
of 5 symbols with 14 characters, scan I 2 of 5 - One Discrete Length, then scan 1 followed
by 4. In case of an error, or to change the selection, scan Cancel on page
D-7 .
I 2 of 5 - One Discrete Length