weber 5000 Series - Manual (Page 23)

23
The hose and regulator are connected in the following
manner:
Slide back the collar of the quick disconnect on the tank
valve. Push the male fitting of the regulator into the quick
disconnect, and maintain pressure. Slide the collar
closed. Figure 33 (a). Figure 33 (b) shows the quick
disconnect engaged and various components of the tank
and regulator. Regulator vent hole should be at 3, 6, or 9
o'clock. It should not be pointed up. Figure 33 (c).
Figure 33
Turn so regulator vent
does not collect water
Hose
Tank lock
wing nut
Quick disconnect
engaged
Valve handwheel
close clockwise
Tank valve
Collar
Male
fitting
Pressure
relief valve
Tank
Regulator
Regulator
vent
(a)
(b)
(c)
Step 24
Connect LP tank
ƽWARNING: Make sure that the LP tank valve is
closed. Close by turning clockwise.
Hook the LP tank onto the fuel scale. Loosen the tank
lock wing nut. Swing the tank lock down. Tighten the
wing nut. Figure 32.
Figure 32
F
E