weber 5000 Series - Manual (Page 27)

27
Step 29
Install the lid
You will need: lid, two hinge pins and two hair pin cotters.
Set the lid in place. Align the hinges at the rear of the
barbecue. Insert hinge pins from the outside. Insert hair
pin cotters into the small holes in the hinge pins.
Figure 44.
Figure 44
Hair pin cotter
Hinge pin
Step 30
Install tool holders, control panel, burner control
knobs and FlameCheck button
You will need: three tool holders, control panel, three
burner control knobs and FlameCheck button.
Hook the tool holders over the frame rail. Figure 45.
Set the control panel in place over both frame braces.
(Hold the Crossover Ignition button up while setting the
control panel in place.) Place your thumbs over the
control panel push-in buttons and push them into the
frame brace until they snap into place. Figure 45 (a).
Push on the burner control knobs and FlameCheck
button. Figure 45 (b).
Figure 45
Hole in frame brace
Tool holders
(a)
(b)
Control panel
push-in buttons