Wolfgang Puck BBLFP001 User Manual
Page 6
Assembling Your
Food Processor Attachment
Using Your
Food Processor
10
9
1
Be sure the unit is unplugged. Place the work bowl on the
food processor gear box collar and twist counter-clockwise to lock
in place (see figure 1).
2
Place the assembled work bowl and gear box onto the
motor base.
3
If using the stainless steel chopping blade simply place it over
the shaft and allow it to fall freely to the bottom of the bowl.
Do not force the blade into the bowl. If the blade does not fall
freely simply turn it slightly left or right and place it onto the
shaft (see figure 2).
4
If using the reversible slicing / shredding disc first place the
stem adapter onto the gearbox shaft with large opening facing
down (see figure 3) and allow it to fall freely down onto the shaft.
Do not force stem adaptor onto the shaft. Then place the
slicing/shredding disc onto the stem (see figure 4) by matching
the shape of the stem adaptor to the slicing/shredding disk.
a. If shredding ensure that the raised shredding holes are on
top, if slicing ensure the raised slicing blade is on top.
5
Place the lid on the bowl by turning it counter-clockwise until
the lid clicks into place (see figure 5). The feed tube should be
in the same position and side as the handle. Place the food
pusher into the feed tube (see figure 6).
Note: Your food processor features a safety interlock system.
The unit will not operate unless the bowl and bowl cover are
properly aligned and locked into place.
Plug unit into a 120-volt 60 Hz AC only outlet. Turn the unit
on by pressing the On/Off button and then pressing the “Proc”
button. Use the food pusher when using the slicing or
shredding disks. Press the food down slowly and steadily
with the pusher.
IMPORTANT: Use GENTLE force to press down on the food
pusher. Excessive force could cause damage to the disk.
6
To stop your food processor, press the on/off button or
re-press the “Proc” button. Wait until the blade or disc comes to
a complete stop before removing the lid or bowl.
The feed tube on the bowl can be used to add ingredients for processing. Use the
food pusher to push ingredients through the feed tube. You can also use the pusher
to seal off the feed tube while the appliance is running to prevent dust from entering
or foods/liquids from escaping.
Reversible Slicing and Shredding Disc
Use this disc for slicing and shredding fruits, vegetables, cheeses
and more.
•
Precut large chunks of food to fit the size of the feed tube.
•
For best results, fill the feed tube evenly.
•
Press the ingredients down slowly and steadily with the pusher.
IMPORTANT: Use GENTLE force to press down on the food pusher. Excessive force
could cause damage to the disk.
•
When processing large quantities, process small batches at a time and empty the
bowl between batches. Caution: Blades are very sharp. Use care when handling.
Stainless Steel Chopping Blade
Use the stainless steel chopping blade for chopping, mixing,
blending, pureeing and preparing crumbs, and short crust pastry.
•
Cut food into 3/4” pieces for best results.
•
Use the pulse feature to prevent over-processing.
•
Most foods should take 10 to 60 seconds to process. Avoid
letting the appliance run continuously.
•
If food sticks to the blade or side of bowl while processing, turn the unit off,
remove the lid, and use a spatula to remove or scrape down the ingredients.
When using the stainless steel chopping blade to chop, mince or puree, do not exceed 2
cups of liquid ingredients or 3 cups of dry ingredients. Use maximum quantity, and
then empty bowl for another batch.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6