Weider WEBE06110 - Manual (Page 7)

7
3. Attach the Frame (2) to the Crossbar (3) with two
M8 x 55mm Bolts (25) and two M8 Nylon Locknuts
(13).
Do not tighten the M8 Nylon Locknuts (13) yet.
5. Tap a 38mm Square Inner Cap (32) into each end
of the Leg Lever (4).
Tap a 25.4mm Round Inner Cap (21) into each end
of the weight tube.
4. Press a 50mm Square Bushing (31) onto each
Upright (1, 15) and tap them into place with a rub-
ber mallet.
Slide a Weight Rest (16) into the Right Upright (1).
Align one of the adjustment holes in the Weight
Rest with the adjustment hole in the Upright.
Tighten an Adjustment Knob (20) into the adjust-
ment hole in the Upright.
Attach the other Weight Rest (16) to the Left
Upright (15) in the same manner.
Attach the Left Barbell Hook (24) to the left Weight
Rest (16) with an M8 Washer (17) and an M8 Nylon
Locknut (13).
Note: Make sure that the Barbell
Hook is on the inside of the Weight Rest. Attach
the Right Barbell Hook (23) to the other Weight
Rest in the same manner.
3
4
5
13
25
16
16
31
15
32
21
4
21
32
Weight Tube
20
20
31
1
25
3
2
24
23 17
17
13
13