Windster WS-38 - Manual (Page 17)

Install the range hood
to the desired position Check and fix the
ower chimney
bracket 1. Set 6” round ducting
collar or
2. Set rectangular starting
collar (check manual)
Check the desired length of
chimney and mark the position
for upper chimney bracket then
fixed. each section 19-1/2” (50cm)
in length maxi extention length
38” (96.5cm) Install the 6” piping tube or
7” piping tube (Ref fig 3-2
use converter), or rectangular
piping exhaust outlet.
all piping tubes are not
included.
Note:
1 2 3-1 3-2
4
5
7” round converter collar
(for 7” exhaust piping)
" " "
"
"
Tape all joints in ducting and all gasketed opening on hood for a tight seal. Note:
Slide the chimney
(upper + lower)
into the base
Check 2 screw holes Fasten 2 screws
6
7 8 9
Extend the upper chimney
up to the desired position
" "
"
9
>
Check 2 screw holes
and fastened
(complete finished)
10
"
"
1.Duct cover and extension duct cover fitment may vary depend on the mounting height of
the range hood.
2.Make sure you can easily peel the white protection pvc film after installation, otherwise
please peel it before chimney installation.
Note:
o o r
Chimney Installation Chart (optional)
?
Mounting range hood without cabinet
15