Westell Technologies WireSpeed ADSL Modem 030-300166A iii - Manual (Page 33)

WireSpeed ADSL Modem
User Guide
030-300166A 30 Advanced Configuration
LAN PC IP Address
This IP address serves two purposes. If DHCP is enabled, this is the IP address that will be assigned to the DHCP client
computer. If Static NAT is enabled, this is the IP address to which that traffic will be directed.
The default value is 192.168.0.10.
Inactivity Timer Timeout
WebShare provides an Inactivity Timer that closes an active PPP session if there has been no traffic through the modem
from or to any user. The timeout value may be adjusted on the LAN Advanced Configuration window. For a session to be
“always on”, select the Inactivity Timer Disable option.
The Inactivity Timeout Value determines the length of time a session will remain connected with no data flow in
either direction. The default setting is disabled. To enable, select LAN Advanced from the Management menu. In
the LAN Advanced Configuration window, select the Enable option and enter an Inactivity Timeout time in
minutes. The valid range is from 0 to 9999 minutes. A zero has the same effect as disabling the timer.
VPI/VCI Parameters
Viewing VPI/VCI Parameters
Your service provider will provide you with a VPI (Virtual Path Indicator) and VCI (Virtual Channel Indicator) which are
path assignments for your ADSL connection. To verify your VPI/VCI settings, select LAN Advanced from the WebShare
Home Page Menu.
The WebShare LAN Advanced Configuration window shows the current configuration settings.
NOTE
Westell modems are shipped with VPI/VCI preset for your area. If these need to be
changed, contact your service provider for the correct settings and follow the
instructions on the next page.