Winix Air Cleaner - Manual (Page 10)

9
PREPARATION
• Press and slide the back cover of the
remote to remove.
• Insert batteries as shown.
• Close the back cover.
BATTERY USE
• The batteries for the remote control are
for initial use only. Change the batteries
when necessary.
• When replacing the batteries, replace
both at once with 2 new AA batteries.
• Incorrect battery usage may cause
battery fluid leakage and/or damage.
• When not using the remote control for
an extended period of time, remove the
batteries.
• Avoid dropping or damaging the remote
control. Keep remote control away from
direct sunlight or heaters.
USING THE REMOTE CONTROL
Proper conditions
• Operate the remote control facing the
air cleaner.
• Operate within 20 feet of the air cleaner.
Poor conditions that may impair
operation
• Any location where there is inverter
lighting equipment or electronic
spontaneous lighting equipment.
• When objects or furniture are located
between remote and air cleaner.
• When air cleaner unit is located in direct
sunlight.
• In areas where fluorescent lighting is
flickering due to worn out bulbs.
POWER
Use the POWER button to turn the power
on and off. A short "beep" will sound
when you turn the unit on or off. Once
the unit is on, it will automatically switch
into Automatic operation. Turn the unit to
manual control by pressing one of the
FAN CONTROL buttons.
TIMER
This button is used to set the timer.
Press the button repeatedly to set the
unit to run for 2 or 4 hours or to cancel.
Each time you press the button, it will
advance to the next pre-set amount
of time. The indicator light on the unit
will show the remaining amount of time.
The unit will stop operating when the set
amount of time runs out.
FAN CONTROL
• UP
Use this button to switch from
Automatic operation and increase the
fan speed level.
• DOWN
Use this button to decrease the fan
speed level.
TURBO
Use this button to switch from
Automatic operation and begin the
maximum amount of room cleaning
and air movement.
AUTO/SLEEP
• When unit is first turned on it
automatically defaults to auto mode.
• Pressing AUTO/SLEEP button once
activates Energy Saving mode. (Fan
speed will not increase past level
three.)
• Pressing AUTO/SLEEP button a
second time activates Sleep mode.
(Fan speed will not increase past
level one.)
PLASMA ON/OFF
Use this button to turn the
PlasmaWave TM generator on or off.
REMOTE CONTROL
* 5000B does not come with remote a control.